High speed machining: A review from a viewpoint of chip formation

Toshiyuki Obikawa, Masahiro Anzai, Tsuneo Egawa, Norihiko Narutaki, Kazuhiro Shintani, Etsuo Takeoka

Research output: Chapter in Book/Report/Conference proceedingConference contribution

9 Citations (Scopus)

Abstract

This paper describes strong nonlinearity in log V-log L relationship, which is often found in machining of supperalloys, titanium alloys, hardened steels, cast irons, etc. The nonlinearity plays an important and favorable role in extension of life-span cutting distance at higher cutting speeds; that is, in a certain range of cutting speed, life-span cutting distance increases with cutting speed. Results of tool wear in a sliding test and cutting experiments, which showed the evidences of strong nonlinearity, were investigated and the mechanisms causing the nonlinearity were discussed.

Original languageEnglish
Title of host publicationAdvanced Materials Research
Pages578-583
Number of pages6
Volume188
DOIs
Publication statusPublished - 2011
Event4th International Conference on High Speed Machining, ICHSM2010 - Guangzhou
Duration: 2010 Oct 92010 Oct 10

Publication series

NameAdvanced Materials Research
Volume188
ISSN (Print)10226680

Other

Other4th International Conference on High Speed Machining, ICHSM2010
CityGuangzhou
Period10/10/910/10/10

    Fingerprint

Keywords

  • High speed machining
  • Life-span cutting distance
  • Machinability improvement
  • Tool life

ASJC Scopus subject areas

  • Engineering(all)

Cite this

Obikawa, T., Anzai, M., Egawa, T., Narutaki, N., Shintani, K., & Takeoka, E. (2011). High speed machining: A review from a viewpoint of chip formation. In Advanced Materials Research (Vol. 188, pp. 578-583). (Advanced Materials Research; Vol. 188). https://doi.org/10.4028/www.scientific.net/AMR.188.578