A bent, crossed-wire antenna with vertical parasitic elements: Formation of a circularly polarized conical beam

Kazuhide Hirose, Takehisa Wada

研究成果: Article

抜粋

A novel crossed-wire antenna backed by a ground plane is proposed and analyzed using the method of moments. Two wires are crossed and fed in phase at the crossing point to radiate a conical beam. To make the conical beam circularly polarized, the crossed wires are bent and four vertical parasitic elements (PE) are added. The antenna is characterized by its simple feed and CP radiation at low elevation angles. First, the effects of the PE location on the radiation characteristics are investigated for crossed wires of a half wavelength. When the PE location is appropriately chosen, the antenna radiates a CP conical beam. Next, attention is paid to CP radiation in a wide range of elevation angle. Calculations show that the angle range where the axial ratio is less than 3 dB increases to 65° from 15° for a changed crossed-wire length. The maximum CP radiation is obtained at an elevation angle of 35°. Finally, the frequency characteristics are studied and the bandwidth for a 3-dB axial ratio criterion is found to be 8%.

元の言語English
ページ(範囲)23-30
ページ数8
ジャーナルElectronics and Communications in Japan, Part I: Communications (English translation of Denshi Tsushin Gakkai Ronbunshi)
86
発行部数2
DOI
出版物ステータスPublished - 2003 2
外部発表Yes

ASJC Scopus subject areas

  • Computer Networks and Communications
  • Electrical and Electronic Engineering

フィンガープリント A bent, crossed-wire antenna with vertical parasitic elements: Formation of a circularly polarized conical beam' の研究トピックを掘り下げます。これらはともに一意のフィンガープリントを構成します。

  • これを引用