Electrochemical properties of Ti45-xZr 30+xNi25 (x = -4, 0, 4) quasicrystal and amorphous electrodes produced by mechanical alloying

Youhei Ariga, Akito Takasaki, Cihiro Kuroda, A. Kulka

研究成果: Article

10 引用 (Scopus)

抜粋

The effect of substitution of Zr for Ti on the discharge performance of electrodes consisted of Ti45-xZr30+ xNi25 (x = -4, 0, 4) powders produced by mechanical alloying (MA) and subsequent annealing was investigated by a three-electrode cell at room temperature. All the powders after MA were amorphous, but a subsequent annealing caused the formation of the icosahedral (i) quasicrystal phase with a Ti2Ni type crystal phase as the second phase. The discharge capacities for both the amorphous and the i-phase electrodes decreased with increasing amount of Zr substituted for Ti. The maximum discharge capacity achieved was about 130 mA h/g from a (Ti49Zr26Ni 25) i-phase electrode at the first discharge process. The discharge capacities of the amorphous electrodes were lower than those of the i-phase ones if the composition levels were alike.

元の言語English
ページ(範囲)S251-S254
ジャーナルJournal of Alloys and Compounds
580
発行部数SUPPL1
DOI
出版物ステータスPublished - 2013 4 29

ASJC Scopus subject areas

  • Mechanics of Materials
  • Mechanical Engineering
  • Metals and Alloys
  • Materials Chemistry

フィンガープリント Electrochemical properties of Ti<sub>45-x</sub>Zr <sub>30+x</sub>Ni<sub>25</sub> (x = -4, 0, 4) quasicrystal and amorphous electrodes produced by mechanical alloying' の研究トピックを掘り下げます。これらはともに一意のフィンガープリントを構成します。

  • これを引用