Formability of AZ31 magnesium alloy sheet in dry press forming using diamond-coated dies

S. Tsuda, S. Yoshihara, S. Kataoka

研究成果: Conference contribution

3 被引用数 (Scopus)

抄録

Dry press forming which hasn't used lubricants in the process is the attractive forming technique of zero emission for the lubricants. As one of the dry press forming techniques, the usage of dies coated with a chemical vapor deposition (CVD) diamond film, which are expected to be applied to forming tools owing to their high tribological properties, abrasion resistance and heat resistance, has been proposed. Magnesium alloys have attracted attention owing to their advantages over what such as, high specific strength and ease of recycling. However, they have intractable characteristics, and it is necessary to perform the forming technique at high temperature and to consider lubrication condition. In this study, diamondcoated dies were used in the deformation of magnesium alloy sheets without lubricants in press forming, and the formability of magnesium alloy and its effect on the surface texture of a formed-cup were investigated. Dry deep-drawing tests and dry ironing tests were carried out to estimate the effect of the diamond-coated dies on the formability of magnesium alloy sheets. Furthermore, the formability obtained using the above-mentioned tests was compared with that obtained in tests using non-lubricant dies with traditional lubricant. AZ31 magnesium alloy sheets (thickness: t0=0.5 mm) were deformed at 200 °C in dry deep-drawing tests. From the results, it was found that what can be deformed using diamond-coated dies. Moreover, a 20 % reduction in drawing force was confirmed compared with the usage of the traditional lubricant (MoS2). Meanwhile, dry ironing tests were performed under conditions of 10 % ironing ratio by a method similar to the dry deep-drawing tests. In general, the ironing process, which is the most difficult step in lubrication in sheet forming, has been enabled by the diamond coating technique. Furthermore, it was observed that the surface roughness of the formed-cup walls using the diamond-coated dies was 0.4 μmRz, and, 1.3 μmRz in case of MoS2. It was confirmed that the application of diamond-coated dies improved the surface roughness of the formed-cup. It produced an improvement in the formability of magnesium alloys compared with the traditional lubrication technique (use of MoS2). It was concluded that the validity of the use of diamond-coated dies became clear.

本文言語English
ホスト出版物のタイトルProceedings of the ASME International Mechanical Engineering Congress and Exposition 2009, IMECE 2009
出版社American Society of Mechanical Engineers (ASME)
ページ15-20
ページ数6
ISBN(印刷版)9780791843772
DOI
出版ステータスPublished - 2010 1月 1
外部発表はい
イベント2009 ASME International Mechanical Engineering Congress and Exposition, IMECE2009 - Lake Buena Vista, FL, United States
継続期間: 2009 11月 132009 11月 19

出版物シリーズ

名前ASME International Mechanical Engineering Congress and Exposition, Proceedings
4

Other

Other2009 ASME International Mechanical Engineering Congress and Exposition, IMECE2009
国/地域United States
CityLake Buena Vista, FL
Period09/11/1309/11/19

ASJC Scopus subject areas

  • 機械工学

フィンガープリント

「Formability of AZ31 magnesium alloy sheet in dry press forming using diamond-coated dies」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル