Investigation of tensile-compressive poof strength of representative PM steels for automotive applications

Akira Yoshida, Akira Fujiki

研究成果: Article

抜粋

A sintered part for automobile has been growing so far. Also, demands for higher strength of the materials are increasing. The compressive strength becomes more important in their requirement. However there are few detailed studies on compressive properties of sintering materials. Generally, it is thought that it was considered compression and tensile proof stress equal in strength of materials. It is important that compressive properties are measured precisely from the situation of the design. This study investigated the compression properties and simulated it about the stress behavior of sintering materials. In this examination, all sintered test pieces showed higher compressive proof strength than tensile proof strength. And the simulation, in elastic level, supported these results.

元の言語English
ページ(範囲)254-257
ページ数4
ジャーナルFuntai Oyobi Fummatsu Yakin/Journal of the Japan Society of Powder and Powder Metallurgy
59
発行部数5
DOI
出版物ステータスPublished - 2012 5 1

ASJC Scopus subject areas

  • Mechanical Engineering
  • Industrial and Manufacturing Engineering
  • Metals and Alloys
  • Materials Chemistry

フィンガープリント Investigation of tensile-compressive poof strength of representative PM steels for automotive applications' の研究トピックを掘り下げます。これらはともに一意のフィンガープリントを構成します。

  • これを引用