Isotropic bulk exchange-spring magnets with 134 kJ/m3 prepared by spark plasma sintering method

Hideaki Ono, Norihisa Waki, Munekatsu Shimada, Tatsuo Sugiyama, Akira Fujiki, Hiroshi Yamamoto, Masato Tani

研究成果: Conference article査読

37 被引用数 (Scopus)

抄録

Densification of exchange-spring magnet ribbons of NdxFe85-xCo8V1B6 (x = 7-11) alloys has been investigated. The starting ribbon powders containing amorphous parts were prepared by melt spinning and were compacted by using a Spark Plasma Sintering (SPS) method. SPS is a type of solid compression sintering similar to hot-pressing and the sintering promotion factor is self heat generation by electric discharges between particles when the on-off D.C. pulse is applied. The bulk magnets indicated the springback phenomenon, pointing to multiple phases of the Nd2Fe14B type and the α-Fe type, and had isotropic magnetic properties. With increasing Nd content, Br decreased from 1.05 T to 0.82 T and HcJ increased from 256 kA/m to 832 kA/m. These changes were equivalent to those of the starting ribbons following annealing. The grain sizes of these bulk magnets were about 40 nm when x = 7-11. Under optimum preparation conditions, bulk Nd10Fe75Co8V1B6 magnet indicated (BH)max = 134 kJ/m3 (16.8 MGOe).

本文言語English
ページ(範囲)2552-2554
ページ数3
ジャーナルIEEE Transactions on Magnetics
37
4 I
DOI
出版ステータスPublished - 2001 7
イベント8th Joint Magnetism and Magnetic Materials -International Magnetic Conference- (MMM-Intermag) - San Antonio, TX, United States
継続期間: 2001 1 72001 1 11

ASJC Scopus subject areas

  • Electronic, Optical and Magnetic Materials
  • Electrical and Electronic Engineering

フィンガープリント 「Isotropic bulk exchange-spring magnets with 134 kJ/m<sup>3</sup> prepared by spark plasma sintering method」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル