The research on high precision machining of vertical wall

Kenshiro Tamaki, Takeshi Akamatsu, Masahiro Anzai, Takekazu Sawa

研究成果: Paper査読

抄録

In order to investigate the influence of cutting condition to the wall precision in finishing process of high hardened steel, we conducted some experiments changed cutting parameters(cutting speed Vc, feed rate fz, axial depth of cut ap ). The result is that the most impact factor is the axial depth of cut. It was few changed of the wall precision in changing Vc and fz. On the other hand, by decreasing ap, the cutting force is tend to be reduced dramatically. Therefore, we surmise that the tool deflection is suppressed, and the wall deflection is also improved. The result compared with cutting direction is that the wall precision machined by up cut milling is higher than down cut milling. In the case of small ap, when ap and flute length of the endmill is the same, it is possible to machine the higher wall precision than the machining by using the long flute length endmill, without contacting the cutting edge of the tool shank side with the wall surface.

本文言語English
出版ステータスPublished - 2018
イベント21st International Symposium on Advances in Abrasive Technology, ISAAT 2018 - Toronto, Canada
継続期間: 2018 10 142018 10 16

Conference

Conference21st International Symposium on Advances in Abrasive Technology, ISAAT 2018
国/地域Canada
CityToronto
Period18/10/1418/10/16

ASJC Scopus subject areas

  • 材料力学
  • 産業および生産工学
  • 機械工学
  • 材料科学(全般)

フィンガープリント

「The research on high precision machining of vertical wall」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル